SET

SET - SET Disk Attributes

The SET sub command allows you to set or clear the read-only status of a device.  Note that this cannot affect a device that is inherently read-only or that is set to read-only due to a hardware setting, such as a switch.

SET Dialogue

Init> DISK SET

Response - Type DISK SET at the main Init prompt.

Disk set (DISKA0) >

Explanation - SET prompts you for the disk to change.  The default is shown in parentheses.

Response - Press Enter to choose the default disk or enter the name of the disk to change.

Disk set DISKA0>

Explanation - SET prompts you for the option to use on the shown disk.

Response - Enter the option to use.    If you type a ? or HELP in response to the prompt, you will be shown the help text at this level.